Please use resin material mortar, use a machine mixer, add water to mix the mortar (adjust the amount of water added according to the construction conditions). Paste with mortar, implement the bottom thickness of 3-5mm, and apply upward continuously. As shown in the figure, the thickness of the coating is 3-5mm, and the area of one coating should be within 2-3m2. The rotation time after application should be within 30 minutes.
When pasting, please implement the improved pressure pasting technique; secondly, prepare mortar with a thickness of 4-6mm, apply stacked stone tile evenly, and paste it straight in order; in order to make the adhesive surface have no gap, please use special tools to make the pasted stacked stone tile enter Inside the mortar, at the same time, use a certain force to make the product stick better, and the extruded mortar is applied to the places with gaps, so that there are no gaps on the surface.
In principle, please implement the seam method, and the material of the seam should use the material that is blended on site, or the ready-made blended material; after pasting, the material will harden, and the seam part should be refilled with hoses and soft tubes; If there is excess mortar at the seam, use a brush to lift stacked stone tile off to make the surface smooth; please press the seam again when the seam seems to be hardened; after pressing the seam, please remove the seam residue.
Please use a brush to remove the plaster attached to the surface; please clean stacked stone tile with a rag and a little less water after construction; please avoid acidic liquids.
