Pink Marble Mosaic Tile

This pink marble mosaic tile brings a touch of elegance to any space. Made from high-quality marble, it adds a luxurious and refined look to your floors, walls, or backsplash. Its unique pattern and durable construction make it a practical and beautiful choice for your interior design needs.

1. Selection Raw Material: According to different designs and customer requests, we select blocks and slabs with suitable colors and veins to increase the yield and avoid waste.

2. Monitoring the whole process: From cutting to mounting the workers are all well aware of the standards and kick out the unqualified chips on sight to avoid wasting more sources and our QC crews make sure of that.

3. Checking pc by PC: Checking pc by pc of finished products according to customer's requirements. Any defective ones will be revised before being packed.

Pre-laying Before installation, pre-laying should be done in accordance with the construction and installation drawings. When the area is large, join the numbered schematic diagram. Ensure that the pink marble mosaic tile and the actual size of the installation surface are coordinated. If there is a gap in the middle part of the splicing during pre-laying, the glue and gauze on both sides of the mosaic joint should be cut and cleaned until the joints are properly coordinated. Make auxiliary lines or marks on the installation surface to ensure that the position of each piece of mosaic can be accurately fixed. Paving: Use a 2-3MM serrated spatula to evenly spread the adhesive on the base layer, with a thickness of 3-5MM. Align the single piece of mosaic to the gap according to the drawing and place it on the combed adhesive. The gap between the two pieces should generally be roughly the same as the gap between the small particles on each piece. Place a flat thick wooden board on the pink marble mosaic tile surface and beat it evenly with a rubber hammer to ensure a firm bond. If a certain mosaic is too high or too bottom, the particles must be removed and leveled by reducing or increasing the adhesive. If the installation surface is a wall, in principle, it should be laid from bottom to top, and it should not be laid too high at one time to prevent collapse caused by heavy weight. Please use auxiliary supports to make it close to the wall with a certain degree of The support can be removed only after the initial strength. When applied in a water environment, it must be waterproof and crack-proof, and it is recommended to use special adhesives and caulks with good waterproof performance. Sealing After the moisture is moderately dried and has the initial strength, clean the surface of the mosaic with a sponge moistened soft cloth, and then wipe it with a clean dry cloth, and you can begin to caulk. Use a wooden or rubber spatula to pour the caulk into the crevices of the pink marble mosaic tile. After the filling of the caulk is completed, the moisture has been properly dried and has the initial strength, then the cleaning work can be started. It should be cleaned until the caulking agent is about 1mm below the pink marble mosaic tile surface, and finally the surface is cleaned again with a dry soft cloth until the surface is clean.